TRSS-485 control signal surge protection device
Model: TRSS-485
Color: white / red
Verification: CE
Product working principle
TRSS-485 signal surge protector is connected in series with the front end of the protected device. When the transmission line is subjected to induced lightning and other transient overvoltage surges, the inrush current is discharged to the earth through the protection branch of the surge protector, and the output is output. The voltage is clamped to the voltage range allowed by the device, thus ensuring the safety of the operating equipment.
Product specifications
| Main technical parameters |
TRSS-485 |
| Max continuous operating voltage Uc(VAC) |
24 |
| Voltage protection level Up(V)≤ |
40 |
| Max discharge current (8/20μS) lmax(kA) |
10 |
| Nominal discharge current (8/20μS) ln(kA) |
5 |
| Response time ns |
<1ns |
| Degree of protection |
IP20 |
| Application |
Primary protection for in line |
| Remarks |
Other Uc can be customized
|
|
product description
TRSS-485 signal lightning arrester is mainly used for lightning (overvoltage) protection of equipment entering the equipment along the low voltage control signal line. It is widely used in financial systems, telecommunication systems, transportation systems, stone chemical control systems, such as various data. Transmission line, monitoring control line, instrumentation signal line, etc.
Product Features
1, with overcurrent, overvoltage, clamp triple protection.
2. When a lightning strike is intruded, there is no need to suspend the power equipment and it will not affect the normal equipment operation.
3, the design is novel, small.
4. Low insertion loss.
5, the transmission rate is high, and the frequency of use is large.
Use attention
1. This product is connected in series.
2. Please select the same type of interface as the protected device interface.
3. The IN of the lightning arrester is the input, the OUT is the output, the input terminal is connected to the external line, and the output end is connected to the input end of the protected device.
4. The PE wire of the lightning protection device must be reliably connected with the ground wire of the lightning protection system. The connection wire is required to be short, thick and straight.
Company Profile
Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.
Product Tags:
|
|
Industrial Control System SPD Network Surge Arrester RS485 Signal Surge Protection Device Images
|
